You’re keen on photographing on the seashore or desert. However how do you retain sand and crud out of your tripod? Listed here are a number of ideas!
Prolong the underside section first
All the time lengthen the underside section first. You may must jam your tripod six inches or extra into the watery sand on the coast or some sand dunes within the desert. Nevertheless, on this method, you possibly can cut back the sand going into the locks.
Wipe and rinse your tripod
I’m admittedly responsible of not doing this sufficient within the desert, though I do that constantly on the seashore. Nevertheless, wiping your tripod with a humid material after utilizing it does wonders for holding the crud out of your locks and the inside of your tripod legs.
In case you don’t have a humid material or towel out there, attempt to see should you can rinse them off elsewhere or, on the very least, use one thing dry to wipe it off.
Test the underside of your tripod
Many tripods include rubber ft. If these are free or fall off, this could expose an open screwhole on the underside of your legs. Sadly, this can be a surefire method to fill the within of your tripod legs filled with crud. You don’t need that, do you? No, after all not! Seal these up by getting new rubber ft or inserting a screw in there to stop this.
Lube your tripod
Regardless of our greatest efforts, typically a tripod will get grit or sand or dust inside it. The legs won’t slide easily out or in. You may hear some crunching once you slide the legs or should you use the locks. You might must take it aside, clear it and lube it with marine grease. Put it again collectively, and it’s nearly as good as new!
Good high quality tripod firms typically have particular instructions for a way to do that on their web site or proprietor’s guide. As with every tools, a little bit of care and upkeep is an exquisite factor.